Viewing The Html Pages - WAGO -I/O-SYSTEM 750 User's Installation And Configuration

80 • Fieldbus controller 750-842
Starting up ETHERNET TCP/IP fieldbus nodes
Fig. 3-33: Example for the function test of a fieldbus node
3. When the Return key has been pressed, your PC will receive a response from
the controller, which will then be displayed in the DOS prompt.
If the error message: "Timeout" appears instead, please compare your entries
again to the allocated IP address and check all conections.
4. Also note that the TXD/RXD light will flash verifying each response
5. When the test has been performed successfully, you can close the DOS prompt.
The network node has now been prepared for communication.
3.2.6.6

Viewing the HTML pages

The information saved in the fieldbus controller can be viewed as an HTML
page using a web browser.
•
Information on the fieldbus node (Terminal Status):
-
-
•
Information on the fieldbus controller (Controller and Network Details):
-
-
-
-
-
-
-
•
Diagnostic information on the fieldbus controller (Controller Status):
-
-
-
Fig. 3-34: Viewing the information through the HTTP protocol
Example: ping 10.1.254.202
Number of digital, analog or complex modules and their model numbers
Representation of the process image
Order number
Firmware version
MAC-ID
IP address
Gateway address (if applicable)
Subnet mask
Number of transmitted and received packets
Error code
Error argument
Error description
P012910e
G012916d
Modular I/O System
ETHERNET TCP/IP