Gps Offsets; System Setup Summary; Confi Guring Auxiliary Switches - New Leader AGCO NL5258G5 Operator's Manual

Header Controller Operations

GPS Offsets

Editing the task controller GPS offset settings will
determine drop point of material behind chassis.
• Select Towed or Self Propelled and enter GPS
Offset using keypad.
• For single axle towed units, enter the distance
from the center of the hitch pin to the center of the
axle (a). Then enter the distance from the center of the
axle to the center of the spinner disc (b).
• For self-propelled units, enter the distance
from the center of the rear axle to the center of the
spinner disc (a).
• NOTE: For units and trailers with tandem
axles, use the center of the tandem for measurement
reference point.
• Press

System Setup Summary

• Verify all settings are correct. Press
continue or to go back and adjust as necessary.
Confi guring Auxiliary Switches
• Switches must be confi gured before calibration.
• Switchbox switches need to be mapped. Use the Display Monitor's operations manual to map
all switches as necessary.
314732-AA-B
to continue.
to
- 82 -
NL5258G5/NL5300G5
Towed
Self-Propelled
www.New-Leader.com
(800) 363-1771