New Leader AGCO NL5258G5 Operator's Manual page 55

Header Lubrication & Maintenance
Spinner Fins
Visually inspect spinner fi ns daily for build-
up of material and wear. Spinner discs and
fi ns must be kept clean and polished. Even
a small build-up of material on a spinner can
signifi cantly affect the spread pattern. Rough,
bent or worn fi ns will produce poor spread
patterns. Replace worn fi ns and discs as
needed. See Fin Kit Installation Instructions for
replacement part numbers and instructions.
Spinner Defl ectors
Visually inspect spinner defl ectors daily for
build-up of material and damage. Clean as
needed. Even a small build-up of material on a
spinner defl ector can affect the spread pattern.
If damaged, bent or otherwise, replace. See
parts manual for replacement part numbers.
Material & Hillside Dividers
Visually inspect material divider and hillside
dividers (as equipped) daily for build-up of
material and wear. Any build-up of material on
divider components can affect performance.
Clean as needed. Replace worn or damaged
parts as necessary.
replacement part numbers.
Vane Assembly
Visually inspect vane assembly for buildup of
material and wear. Ensure all vanes are free
of buildup and swing freely. Clean vanes and
remove blockages as necessary. See parts
manual for replacement parts.
www.New-Leader.com
(800) 363-1771
See parts manual for
Figure 5 - Spinner Defl ector
Figure 6 - Material Divider
Figure 7 - Vane Assembly
- 55 -
NL5258G5/NL5300G5
Figure 4 - Fin
314732-AA-B