Table of Contents
Advertisement
Installation
Header
Header
INSTALLING BODY
DO NOT WELD ON VEHICLE FRAME! Such welding can lead to fatigue cracking and must be
NOTICE!
avoided.
Connect welders ground directly to one of the items being welded anytime an arc welder is used
NOTICE!
on the vehicle or anything connected to the vehicle. Refer to Manufacturer's instructions.
Disconnect electrical components from electrical system when welding on equipment to
IMPORTANT!
prevent component damage due to power surges or excessive current.
Mounts
Refer to chassis operator's manual for specifi c procedures on tightening mounting
CAUTION
hardware. Failure to follow procedure per chassis manufacturer may result in injury or
machine damage.
Position unit over chassis and align mounts. Carefully lower unit onto chassis.Install mounting hardware
and tighten to specifi ed torque. Refer to chassis operator's manual for specifi c hardware tightening
procedures.
HYDRAULIC HOSE INSTALLATION
If a threaded connection is tightened too tightly, the fi tting or housing into which the
CAUTION
fi tting is placed could be distorted and an unstoppable leak could occur.
Do not use one manufacturer's hose with another manufacturer's fi ttings! Such will void
WARNING
any warranty and may cause premature burst or leak of hydraulic fl uids! Severe injury and/
or fi re could result!
Locate zero pressure case drain port on chassis. Connect this hose to chassis fi rst. Next connect return
hose to return port. Connect pressure hose to pressure port last. Use plastic tie straps as necessary to
support hoses so they will not catch on fi eld obstructions or contact hot or moving parts.
314732-AA-B
- 26 -
NL5258G5/NL5300G5
www.New-Leader.com
(800) 363-1771
Advertisement
Table of Contents
Troubleshooting
