Fan Frame Alarms - New Leader AGCO NL5258G5 Operator's Manual

Controller Operations Header

Fan Frame Alarms

Alarm
Fan Frame Not "Fan Frame must be calibrated prior to
Calibrated
Fan Frame "Fan Frame may move at this time. Keep
Movement
Fan Frame
Movement
During
Calibration
Home Position
Sensor Failure "Home Position Sensor Error. Check
During
Application
Fan Frame Not "Fan Frame Not Responding." + [Sensor
Responding
Fan Frame
Outside
expected operating range. Check sensor
Expected
Operating Range
No Feedback
"No Feedback from Position Sensor." +
from Position
Sensor
www.New-Leader.com
(800) 363-1771
Description
operation." + [Sensor Name]
clear of Fan Frame."
"Fan Frame will move during
calibration."
Sensor and Wiring."
Name]
"Fan Frame position sensor outside
and wiring." + [Sensor Name]
[Sensor Name]
[Fan Frame Enable/Disable] is Enabled,
equipment profi le is active and Fan
Frame position sensor has not been
calibrated.
Upon startup, equipment profi le is fi rst
activated, [Fan Frame Enable/Disable]
is Enabled, and Swath Calibration
has been completed -or- upon user
adjustment of the [Target Fan Frame]
setting.
Fan Frame calibration routine has been
initiated, and system has been signaled
to move Fan Frame.
Conveyor is commanded on, Position
Sensor signal is lost during application.
Conveyor is commanded on, Fan Frame
is commanded to move, and no change
in position is detected from the position
sensor for fi ve consecutive seconds or
longer.
Upon user acknowledgement, dialog
is dismissed. System allows product
application at current Fan Frame
position.
Conveyor is commanded on and system
is not receiving feedback from position
sensor.
- 123 -
NL5258G5/NL5300G5
Trigger
314732-AA-B