Transferring Data; Report Printer; Pc / Pocket Pc - TESTO 330 Instruction Manual

Performing the detection:
> Set the gas type to be detected and perform gas leak testing by
following the instructions described in the documentation of the
gas leak probe.
1. Start detection:
- The gas concentration is displayed, if it exceeds the limit an
alarm signal will sound.
Options:
> [Options]
form of a line graph.
> [Options]
a measurement): Adjusting alarm limits.
> [Options]
during a measurement): Alarm signal disable/enable.
> [Options]
2. End detection:
Pos: 76 /TD/Produkt verwenden/testo 330/testo 330 Überschrift Daten übertragen @ 6\mod_1279258550805_79.doc @ 66583 @ 2
6.3.

Transferring data

Pos: 77 /TD/Produkt verwenden/testo 330/testo 330 Daten übertragen @ 6\mod_1279258680964_79.doc @ 66614 @
6.3.1.

Report printer

To be able to transmit data via infrared or Bluetooth interface to a
Testo report printer, the printer to be used must have been
activated, see Printer, page 36.
Printing out data takes place via
available if a printout is possible.
6.3.2.

PC / Pocket PC

Data transfer to a PC can take place via USB, IrDA or Bluetooth
Data transfer to a Pocket PC can take place via IrDA or Bluetooth
You must also refer to the documentation that comes with the
software.
Pos: 78 /TD/Überschriften/7. Produkt instand halten @ 0\mod_1173789831362_79.doc @ 397 @ 1
[ ].
→
Show Graphic: The readings are displayed in
→
Alarm Limit: (This function is not available during
→
Alarm Signal: (This function is not available
→
Zeroing Probe: Perform zeroing.
[ ].
[Print] or [ ]. The function is only
6 Using the product
®
.
®
.
59