Draught-Measurement - TESTO 330 Instruction Manual

Options
> [Options]
> [Options]
> [Options]
form of a line graph.
> [Options]
numerical values.
> [Options]
during a measurement). Set the system type to be able to
configure the ideal zone (green) of the flue gas matrix, using the
limits pre-configured for each system type.
> [Options]
are deleted.
> [Options]
measurement). Enter limits to be able to configure the ideal
zone (green) of the flue gas matrix.
> [Options]
should be assigned to the x-axis of the display matrix (O2 or
CO2).
> [Options]
during a measurement). Open the readings display menu.
Pos: 63 /TD/Produkt verwenden/testo 330/testo 330_Zugmessung @ 6\mod_1279111642510_79.doc @ 66034 @
3.
6.2.3.

Draught-Measurement

Calling up the function:
✓ A flue gas probe must be connected.
1. [
Performing the measurement:
1. Start measurement:
- Draught zeroing.
→ Clipboard: Data are saved to the clipboard:
→ Save: The readings are saved in a record.
→
Show Graphic: The readings are displayed in
→
Show Numerical
→
System
→
Reset Graphic: The displayed graphical values
→ Limits: (This function is not available during a
→
CO + O2
→
Readings
→
] Measurements
The pressure socket of the instrument must be free (i.e.
unpressurized, not closed).
Do not measure for longer than 5 min, as the drift of the
pressure sensor means that the readings could be outside
the tolerance limits.
[
Values: Data are displayed as
Type: (This function is not available
or CO + CO2: Choose which parameter
Display: (This function is not available
→ →
[OK] Draught
].
6 Using the product
→ [OK].
47