Table of Contents
Advertisement
3.15 STOCK-PICKER HANGER ACCESSORY
NOTE: The stock-picker hanger accessory is available only on the
JLG MSP model and is not authorized for use with any
other JLG lift. This hanger accessory is intended for use in
placing or retrieving stock items such as bicycles, ladders,
etc., on racks or shelves above ground level. Use for any
other purpose is not authorized by JLG.
The hanger accessory is a pivoting arm mounted to the MSP
platform rail. The hanger accessory can be mounted to either
side of the platform individually, or two can be mounted, one on
each side of the platform. Each individual hanger has a maxi-
mum load capacity of 100 lb. (45kg).
The hanger arm can be pivoted out of the way parallel with the
platform side rails when not in use, (the stowed position). The
hanger arm is pinned into position at 90 degrees to the platform
side rails when in use, (the carry position).
Pre-Start Inspection
Prior to use of the hanger accessory, check the following;
• Hanger arm mounting is secure to the platform railing, no
missing or damaged fasteners.
• The hanger arm lock pin is in place and secure.
3121230
SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
THE COMBINED WEIGHT OF PERSONNEL, MATERIALS, EQUIPMENT PLUS ANY
LOAD ON THE HANGER ARM ACCESSORY MUST NOT EXCEED THE MAXIMUM
LOAD CAPACITY OF THE PLATFORM.
Loading and Transporting an Item using the Hanger
Accessory
Use the following steps as a guide when loading and transport-
ing an object with the hanger accessory arm.
1. Keep the hanger arm in the stowed position when not
2. When ready to use, pull the lock pin from the stowed
3. Load the object onto the hanger arm and use the
MSP MACHINE'S EQUIPPED WITH THE OBSTRUCTION SENSING SYSTEM (OSS)
OPTION – OBJECTS PLACED ON THE HANGER ACCESSORY AND EXTENDING
BELOW THE BASE OF THE PLATFORM MAY CAUSE AN OSS DETECTION -
SOUNDING THE HORN AND PREVENTING THE PLATFORM FROM LOWERING.
IF NECESSARY, REPOSITION THE OBJECT OUT OF THE OSS DETECTION ZONE.
– JLG Lift –
in use.
position hole and swing the hanger arm into the carry
position. Place pin in the carry position hole locking
the hanger arm in place.
hanger arm strap to secure the object during trans-
port.
3-45
Advertisement
Table of Contents
