Table of Contents
Advertisement
2.4
DAILY WALK-AROUND INSPECTION
Begin the "Walk-Around Inspection" at item one (1) as noted on
the diagram. Continue around machine check each item in
sequence for the conditions listed in the following check list.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS "OFF" DURING
"WALK-AROUND INSPECTION".
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN COR-
RECTED.
DO NOT OVERLOOK VISUAL INSPECTION OF THE BASE FRAME UNDERSIDE.
CHECK THIS AREA FOR OBJECTS OR DEBRIS WHICH COULD CAUSE EXTENSIVE
MACHINE DAMAGE.
INSPECTION NOTE: On all components, make sure there are no
loose or missing parts, that they are securely fastened, and that no
visible damage, leaks or excessive wear exists in addition to any
other criteria mentioned.
1. Drive and Caster Wheels - Check for any debris stuck
to or around wheels.
3121230
SECTION 2 - PREPARATION AND INSPECTION
2. Base Frame - Check pot-hole-protection system com-
ponents; check for loose wires or cables dangling
below the base.
3. Manual Descent Control Valve - See inspection note
above.
4. Motor/Pump/Reservoir Unit - No evidence of
hydraulic leaks. Hydraulic oil level should be filled level
with the full line.
5. Batteries - Charge if necessary.
6. Platform Assembly and Gate - Quick-Change plat-
form mounting and mounting pins; platform railings;
entry bar or gate in proper working order; MSP - plat-
form fasteners.
7. Platform Control Console - Platform control; placards
secure and legible; emergency stop switch reset for
operation; Control markings legible.
8. Ground Control Station - Main Power Selector Switch
operable; placards secure and legible; emergency stop
switch operates properly.
9. Mast Assembly - Mast sections; slide pads; mast
chains; sequencing cables; platform control and
power cables (on side of mast); power cables properly
tensioned and seated in sheaves; cable sheaves rotat-
ing freely.
– JLG Lift –
2-5
Advertisement
Table of Contents
