Removing A Rug Using Rug Carrier Accessory Arms - JLG 15MVL Operation And Safety Manual

Removing a Rug using Rug Carrier Accessory Arms

This section describes the use of the Rug Carrier accessory in
removing a rug from a horizontal pivoting arm display rack.
1. Select the intended location in the display for removal
of the rug. Open the display rack to provide adequate
space for the MSP lift and rug.
2. With the Rug Carrier Accessory arms stowed, drive the
MSP into position prior to loading the rug.
3. Swing and lock the Rug Carrier Accessory arms into
the carry position.
4. Elevate the platform a few feet. Start to roll the rug
onto the Rug Carrier Accessory arms.
5. Be certain the rug is centered over its length on the
Rug Carrier Accessory.
6. While elevating to the required height for removing
the rug from the display arm, continue to roll the rug
until it is completely rolled up on the carrier arms.
7. Properly remove the rug from the display arm. Never
climb onto the platform rails for any reason.
8. After adequately removing the rug from the display
arm, lower the platform.
9. Remove the rug from the Rug Carrier Accessory. If
required, use an assistant to unload the rug from the
Rug Carrier Accessory Arms.
3121230
SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
1. Roll Rug onto Rug Carrier while Elevating Platform
2. Rug Carrier in Carry Position
– JLG Lift –
1
2
Removing Rug From Display Arm.
3-43