Table of Contents
Advertisement
Machine Power Up using the PSL™
NOTE: When entering code on the key pad, a short beep indi-
cates a properly depressed key, a long beep indicates an
error in depressing key. If an error occurs, you must restart
the code entry process again.
1. Enter the four digit code on the PSL key pad. The
ACCEPT - AMBER LED indicator will be lit if the code is
correct.
2. Press the keypad ON button. The ON - GREEN LED indi-
cator will light and power will be supplied to the
Ground Control Station.
3. At the ground control station, turn the main power
selector switch from OFF to either Platform Control
Mode or Ground Control Mode.
4. The machine will now operate normally.
Machine Power Down
1. At the Ground Control Station set the main power
selector switch to the OFF position.
2. Press the OFF button on the PSL keypad. No LEDs on
the PSL box will be lit.
3121230
SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
Changing the Operator's Code
The PSL Operators Code can be changed by a supervisor should
the need occur. A separate permanent Supervisor's Code
matched to the serial number of the PSL box is included on a
sheet in the PSL user manual supplied with the machine.
1. Enter the Supervisor's code on the key pad. The PRO-
NOTE: ON or OFF cannot be one of the four digits of the new
Operator's code.
2. Enter a new four (4) digit Operator's code on the key-
3. Press the OFF button on the keypad to activate the
NOTE: The new Operator's code will remain in the PSL even when
power is removed from the equipment, or until the Super-
visor changes the Operator's code.
– JLG Lift –
GRAM - RED LED will be lit if correct code is entered.
pad. The ACCEPT - AMBER LED will light up if the new
Operator's code is accepted.
new Operator's code.
3-37
Advertisement
Table of Contents
