N&W Global Vending Krea Installation - Use - Maintenance page 41

W
asH
a
utomatic mixEr WasH
It is possible to set the time for the automatic wash of the
mixers installed.
By setting the time to 24:00, the function is disabled
(default setting).
a
utomatic uNit WasH
This function allows you to set the daily automatic wash
(rotation and dispensing of water) of the espresso unit by
setting the time when to perform the wash.
By setting the time to 24:00, the function is disabled
(default setting).
i
NstaNt DriNks boost
This enables the function for heating the hydraulic circuit
and mixers before the preparation of an instant powder-
based drink.
The heating (dispensing of a small amount of hot water)
occurs if no dispensing has been performed in the mi-
xers during the last 3 minutes.
m
ixEr cooliNg
If the machine is equipped with a cold unit, the function
is enabled.
If no dispensing was made within the last 3 minutes in
the mixers of the cold drinks, a small quantity of cold
water is dispensed before the syrup-based selections.
W
asH passWorD
From this group of functions it is possible to set the
- Mixer wash password
Password to be entered in normal operation (with door
closed) to wash the mixer.
The keyboard takes on the respective numerical values
shown in the figure at the beginning of this chapter.
- Unit wash password
Password to be entered in normal operation (with door
closed) to wash the espresso unit.
The keyboard takes on the respective numerical values
shown in the figure at the beginning of this chapter.
mixEr aND EsprEsso uNit WasH
Enables/disables the washing of the mixers and espres-
so unit.
© by N&W GLOBAL VENDING S.p.A.
a
ccEssoriEs
t
aNk
This function allows you to define whether the machine
water supply is through the mains or internal tanks:
- 0: water supply from the mains;
- 1: internal tank;
p
HotocEll
On the models equipped with "cup sensor" (photocell)
which detects the presence of an object in the dispen-
sing unit.
With the function enabled, if an object is detected in the
dispensing unit, the dispensing of the drink is started.
If the cup remains in the dispensing unit, then the
message "remove the cup" will be shown when the next
selection request is made.
The lamp of the dispensing unit is controlled by the cup
sensor.
The dispensing unit lighting operation mode can be set
as follows:
- 0: lighting always active
- ON: defining the on time of the lighting (in hundredths
of a second) from the beginning of the drink prepara-
tion.
j
ug facilitiEs
This function allows you to set the number of consecuti-
ve dispensing events of a selection for filling a jug.
The number of dispensing events can be programmed
from 1 to 9, and the default value is 5
W
astE rEsEt passWorD
The function allows you to set the password (to be
entered with the door closed) to reset the counter which
manages the coffee waste container.
With the password set to 00000, the password is not
active.
"f - "
rEE vEND passWorD
The function allows you to set the password (to be en-
tered with the door closed) to enable the free of charge
dispensing of the drinks (free vend).
With the password set to 00000, the password is not
active.
"j "
ug facility passWorD
The function allows you to set the password (to be
entered with the door closed) to enable the consecutive
dispensing of a selection for filling a jug.
With the password set to 00000, the password is not
active.
35
09-2013 4485-00