Startup; Introduction; Creating A Console Connection - Oracle Acme Packet 1100 Hardware Installation Manual

5

Introduction

DRAFT

Creating a Console Connection

Prerequisites
Proprietary and Confidential
Creating a Console
Connection
Acme Packet 1100 Hardware Installation Guide
This chapter describes the Acme Packet 1100 startup; this includes the following
tasks:
Powering on the Acme Packet 1100
•
Creating the first console connection to the Acme Packet 1100
•
• Logging in to the Acme Packet 1100
You can perform these actions in any order. However, if your console connection is
configured first, you can observe the booting processes as your Acme Packet 1100
goes online.
This section explains how to create a console connection.
In order to create a console connection to the Acme Packet 1100 you need to
configure the terminal hardware and software appropriately. Ensure that your
terminal is configured with the settings presented in the following table.
Table 5 - 1. Serial Connection Settings
Serial Connection Parameter
Baud Rate
Date Bits
Parity
Stop Bit
Flow Control
Note: Your terminal application and serial port MUST be capable of
operating at 115.2 Kbps for creating a console session.
To create a console connection:
1. Set the terminal application's parameters to match the Acme Packet 1100
default parameters listed in the table above.
Setting
115,200 bps
8
No
1
None

Startup

33