Electrical Connection - KaVo HealOzone 2130 C Instructions For Use Manual

Instructions for use HealOzone 2130 C
|
4 Commissioning 4.2 Connections

4.2.5 Electrical connection

Note
The unit is supplied with a country-specific mains cable as standard.
▶ Check the configured mains input voltage.
The voltage selector is on the rear of the device. The possible settings on the voltage
selector are 115 V and 230 V. The device is set in the factory to a mains voltage of
230 VAC, 50/60 Hz. Check this setting and change it to the existing supply voltage
if necessary.
▶ Plug in inlet connector at the reverse of the HealOzone unit.
▶ Plug end of cable into a socket.
Note
The socket outlet must be properly grounded and meet the respective national
guidelines. For North America, a hospital grade socket outlet is required.
The system is now ready for use and can be switched on at the unit's main switch.
29/57