Leg Rest Actuator - Permobil M400 Corpus HD Service Manual

M400 Corpus HD
5. Remove the leg rest, which is held in place by two screws and
spacers.
4.1.11.2 Mounting leg rest
1. Mount the leg rest using the two screws and spacers. Use a torque
wrench to tighten the screws. Tightening torque 18 lb·ft.
2. Mount the front bracket of the manual adjustment unit/actuator.
Start with the screw and washer. Tighten the screw using a torque
wrench. Tightening torque 35 lb·ft. Then fit the lock nut and
washer on the inside of the bracket.
3. Mount the front ends of the UniTrack rails, they are attached with a
screw from underneath.
4. Mount the leg rest's top cover by carefully pressing its bracket into
place on the leg rest's fixing screws/spacers.
4.1.12

Leg rest actuator

WARNING!
Risk of injury while working on the leg rest
Do not place any weight on the leg rest while working on it.
The following tools are necessary for this task:
• Allen key 5 mm
• Allen key 8 mm
Figure 55. The leg rest is held in place by two screws
and spacers. The front bracket of the actuator is held in
place by a screw and lock nut.
Repairs - Seat
37