Permobil M400 Corpus HD Service Manual page 74

M400 Corpus HD
• Phillips head screwdriver
1. Remove the chassis covers. See
4.2.1.1 Removing the front chassis covers , Page 43,
4.2.1.3 Removing the rear chassis covers , Page 43, and
4.2.1.5 Removing the upper chassis covers , Page 44
2. Switch the main fuse to OFF.
3. Detach the negative cable from the rear battery.
4. Detach the positive cable from the front battery.
5. Remove the main fuse, which is held in place with two nuts.
Note the direction in which the fuse is installed. The ON/OFF
position must match the appropriate sticker on the chassis.
6. Disconnect the cables from the mail fuse by loosening the screws.
4.3.4.3 Mounting the circuit breaker
The following tools are necessary for this task:
• Wrench 6 mm
• Phillips head screwdriver
1. Switch the new main fuse to OFF.
2. Connect the cables to the new main fuse.
3. Fit the new main fuse on the bracket with the two nuts.
Note the direction in which the fuse is installed. The ON/OFF
position must match the appropriate sticker on the chassis.
4. Reattach the battery connection cables to the batteries.
5. Fit the chassis covers. See
4.2.1.2 Mounting the front chassis covers , Page 43,
4.2.1.4 Mounting the rear chassis covers , Page 43, and
4.2.1.6 Mounting the upper chassis covers , Page 44.
6. Switch the main fuse to ON
74
Repairs - Control panel and electronics
Figure 115. On chassis with R-net Control System the
Main Fuse is fitted with two nuts