Permobil M400 Corpus HD Service Manual page 89

M400 Corpus HD
Error message as shown on
display
Inhibit Active
Jstick Cal Error
Latched Timeout
Brake Lamp Short
Left Lamp Short
Right Lamp Short
L Ind Lamp Short
R Ind Lamp Short
L Ind Lamp Failed
R Ind Lamp Failed
DIME Error
Memory Error
PM Memory Error
Bad Cable
Bad Settings
Module Error
System Error
Gone to Sleep
Charging
7.2.6.1 Joystick Error
The most common cause for this error is joystick movement away from
its central position just before or at the moment the control system was
switched on. The moved joystick view is displayed for 5 seconds. If the
joystick is not released during this time, a joystick error is registered.
Even if an error screen is not displayed, the error and the number times
it arises is registered in the system log.
• Ensure that the joystick is in the central position and start up the
control system.
If the error persists, the joystick or joystick module may be defective.
Read more in 7.4 Repairing defective units , Page 98.
7.2.6.2 Low Battery
This occurs when the control system detects that the battery voltage is
lower than 16 V.
Description
Go to section 7.2.6.6 Inhibit Active .
Go to section
7.2.6.7 Joystick Calibration Error .
Go to section
7.2.6.8 Latched Timeout .
Go to section
7.2.6.9 Brake Lamp Short .
Go to section 7.2.6.10 Lamp Short .
Go to section 7.2.6.10 Lamp Short .
Go to section
7.2.6.11 Indicator Lamp Short .
Go to section
7.2.6.11 Indicator Lamp Short .
Go to section
7.2.6.12 Indicator Lamp Failed .
Go to section
7.2.6.12 Indicator Lamp Failed .
Go to section 7.2.6.13 DIME Error .
Go to section
7.2.6.14 Memory Error .
Go to section
7.2.6.15 PM Memory Error .
Go to section 7.2.6.16 Bad Cable .
Go to section 7.2.6.17 Bad Settings .
Go to section
7.2.6.18 Module Error .
Go to section 7.2.6.19 System Error .
Go to section
7.2.6.20 Gone to Sleep .
Go to section 7.2.6.21 Charging .
Troubleshooting - Diagnostics R-net LCD control panel
89