Manual Leg Rest Adjustment Unit - Permobil M400 Corpus HD Service Manual

M400 Corpus HD
4.1.12.1 Removing leg rest actuator
1. Switch off the main power switch on the control panel.
2. Remove the UniTrack rail from the right side of the seat. See
4.1.6 UniTrack rails , Page 27.
3. Remove the actuator contact from the contact block above the
actuator. Remove the contact by pulling it straight out. Loosen the
actuator cabling from its fixing points. Remember how the cabling
is positioned; this helps when you come to re-attach it.
4. Remove the lock nut from the front bracket of the actuator.
5. Remove the actuator, which is held in place by two screws.
4.1.12.2 Mounting leg rest actuator
1. Fit the rear fixing screw (M6x12) and washer for the actuator.
Tighten the screw using a torque wrench. Tightening torque
7.2 lb·ft.
2. Fit the front fixing screw (M10x60), spacer and washer for the
actuator. Tighten the screw using a torque wrench. Tightening
torque 26 lb·ft.
3. Fit the lock nut and washer on the front bracket of the actuator.
4. Secure the cabling for the actuator in its fixing points. Consider the
arrangement of the cables carefully and make sure there is no risk of
them getting trapped or otherwise damaged. Connect the actuator
contact to the contact block on the right side of the seat. Fit the
contact by pushing it straight in at any point.
5. Mount the UniTrack rail on the right side of the seat. See
4.1.6 UniTrack rails , Page 27.
4.1.13

Manual leg rest adjustment unit

The following tools are necessary for this task:
• Allen key 5 mm
• Allen key 8 mm
4.1.13.1 Removing manual leg rest adjustment unit
WARNING!
Risk of injury while working on the leg rest
Do not place any weight on the leg rest while working on it.
38
Figure 56. The leg rest actuator is held in place by two
screws. The actuator cabling is connected to the contact
block above the actuator.
Repairs - Seat