Permobil M400 Corpus HD Service Manual page 23

M400 Corpus HD
3. Remove the seat plates, which are held in place by two screws at the
back edge and two quick-mount clamps at the front. First remove
the screws, then use your hand to carefully push the seat plate from
below to release the quick-mount clamps at the front.
4. Divide the cabling for the seat angle mechanism at the contact on
the cabling. The contact is at the front right corner of the seat angle
mechanism, next to the other cabling.
5. Remove the six screws that hold the seat in place. Have someone
help you by holding the seat while you remove the screws, and then
helping you lift the seat and lay it next to the chassis. Be careful with
the seat cabling.
Figure 20. The seat plates are held in place by two
screws at the back edge and two quick-mount clamps at
the front
Figure 21. The connector is on the cabling at the front
right corner of the seat angle mechanism, next to the rest
of the cabling
Figure 22. The seat is held in place by six screws.
Repairs - Seat
23