Permobil M400 Corpus HD Service Manual page 35

M400 Corpus HD
4. Reassemble the end cover of the backrest profile by pushing it
straight into the end of the profile. Secure the cover by tightening
the screws on the left and right.
5. Reassemble the backrest profile by fitting the hinge and the slewing
bracket into the profile groove on the left and right sides. Slide the
profile downwards until the stop on the bracket and the slewing
bracket is touching the end of the backrest profile on both the left
side and the right. Secure the backrest profile by tightening the two
screws on the left and right. Tighten the screws using a torque
wrench. Tightening torque 7.2 lb·ft.
6. Mount the armrests using the four screws screws. Tighten the screws
using a torque wrench. Tightening torque 7.2 lb·ft.
7. Mount the joint for the backrest slide function using the screw
supplied. Tighten the screw using a torque wrench. Tightening
torque 7.2 lb·ft.
8. Mount the BUS contacts on the contact block and mount the
cabling for the ICS switchbox at the contact on the cabling.
9. Remount the plastic cover on the back of the backrest using the two
screws supplied.
10. Remount the backrest plates. For a detailed description, see
4.1.7.2 Mounting the backrest , Page 30.
Figure 50. The end cover of the backrest profile is
secured using one screw on the left side and one on the
right.
Figure 51. The backrest profile is secured by two
screws on the left and right.
Figure 52. The armrests are held in place by four
screws. The joint for the backrest slide function is held in
place by one screw
Repairs - Seat
35