Permobil M400 Corpus HD Service Manual page 90

M400 Corpus HD
• Check the batteries and their connection to the control system.
If the error persists after the batteries and connections have been
checked, the power module may be defective. Read more in
7.4 Repairing defective units , Page 98.
7.2.6.3 High Battery
This occurs when the control system detects that the battery voltage is
higher than 35 V. The most usual causes for this error are battery
overcharging or a poor connection between the control system and the
batteries.
• Check the batteries and their connection to the control system.
If the error persists after the batteries and connections have been
checked, the power module may be defective. Read more in
7.4 Repairing defective units , Page 98.
7.2.6.4 Brake Error
This occurs when the control system detects a problem in the solenoid
brakes or the connections to them.
1505 - M1 Brake Error (M1; motor connected to M1 on the power
module).
1506 - M2 Brake Error (M2; motor connected to M2 on the power
module).
• Check the solenoid brakes, their cables and the connections to the
control system.
If the error persists after the checks listed above, the power module may
be defective. Read more in 7.4 Repairing defective units , Page 98.
7.2.6.5 Motor Error
This occurs when the control system detects that a motor has been
disconnected.
3B00 - M1 Motor Error (M1; motor connected to M1 on the power
module).
3C00 - M2 Motor Error (M2; motor connected to M2 on the power
module).
• Check the motors, their cables and the connections to the control
system.
If the error persists after the checks listed above, the power module may
be defective. Read more in 7.4 Repairing defective units , Page 98.
7.2.6.6 Inhibit Active
This occurs when one of the inhibit signals is active and is in blocked
mode.
The last two digits of the error code indicate the active inhibit signal.
The code is hexadecimal.
1E01 - For inhibit signal 1.
1E09 - For inhibit signal 9.
1E0A - For inhibit signal 10.
• Switch power off and on. This will deactivate the block mode,
which may remedy the error.
90
Troubleshooting - Diagnostics R-net LCD control panel