Permobil M400 Corpus HD Service Manual page 60

M400 Corpus HD
4. Separate the magnetic brake cabling at the contacts on the cabling.
This is positioned on the inside of the chassis, next to the seat lift.
The contact is mounted together with the drive motor contact in a
holder.
5. Run the connection cable out through the chassis cable duct.
6. Remove the magnetic brake, it's fitted with three screws.
4.2.8.2 Mounting magnetic wheel lock
NOTICE
Check brake release
Check that the brake release works properly. When the brakes are released, it
should not be possible to drive the wheelchair.
1. Fit the magnetic brake with the brake release lever pointing upwards
using the three screws.
2. The brake release lever has an end position screw which is mounted
in different positions depending on if the magnetic brake is mounted
on the chassis right or left drive motor. On delivery of a new brake
release, the end position screw is mounted on the end of the brake
release lever. Fit the end position screw to the side of the brake
release lever that points agains the center of the chassis.
3. Connect the magnetic brake cable at the connector. This is
positioned on the inside of the chassis, next to the seat lift. Fit the
contact together with the drive motor contact in a holder.
4. Fit the drive motor cover. See
4.2.1.12 Mounting the drive motor covers , Page 46.
5. Fit the chassis cover. See
4.2.1.6 Mounting the upper chassis covers , Page 44.
60
Repairs - Chassis
Figure 91. The contacts are mounted together in a
holder
Figure 92. The magnetic brake is fitted with three
screws
Figure 93.