Permobil M400 Corpus HD Service Manual page 19

M400 Corpus HD
5. Remove the four fixing screws.
6. For power seat lift on wheelchair with VR2: Separate the seat
lift cabling at the contacts on the cabling.
7. For power seat lift on wheelchair with R-net: Disconnect the
seat lift cabling from the ICS general module.
8. Lift the Power Seat Lift/Fixed Seat Post straight up out of the
chassis.
4.1.1.3 Mounting the seat lift
WARNING!
Risk of crushing - two people are required
Two people are required for this task due to heavy lifting. Watch out for
moving parts, there is a risk of crushing.
The following tools are necessary for this task:
• Allen key 5 mm
1. Fit the Power seat lift/Fixed seat post into the chassis using the four
screws.
2. For power seat lift on wheelchair with VR2: Connect the seat
lift cabling at the connector on the cabling.
3. For power seat lift on wheelchair with R-net: Connect the seat
lift cabling to the ICS general module.
4. Fit the seat including the seat tilt mechanism if the wheelchair is
equipped with such device. See 4.1.4.2 Mounting seat , Page 27
5. Fit the upper chassis cover. See
4.2.1.6 Mounting the upper chassis covers , Page 44.
Figure 11. The Fixed Seat Tube/Power Seat Lift is
attached with four screws
Figure 12. ICS General Module is fitted at the rear of
the chassis
Repairs - Seat
19