Permobil M400 Corpus HD Service Manual page 69

M400 Corpus HD
4.2.13.3 Rear lights and turn signals
Figure 102. Rear lights cabling connections
1. Left indicator
2. Right indicator
3. Left rear light
4. Right rear light
Removing rear light and turn signal
The rear lights and indicators are delivered complete with the chassis
rear cover.
1. Switch off the main power switch on the control panel.
2. If the upper chassis cover isn't removed, remove it's rear knobs and
lift it's rear end to release the rear chassis cover, raise the seat if
needed. Remove the rear chassis cover by lifting it upwards/
backwards, be sure to disengage the tab.
3. Disconnect the rear lights and indicators cabling. These are
connected to the connectors at the rear of the wheelchairs chassis.
Mounting rear light and turn signal
1. Reconnect the rear lights cabling.
2. Fit the cover partially inside the chassis at the lower edge.
3. Make sure the upper cover holds the rear cover and remount the
two knobs.
Repairs - Chassis
Figure 103. The rear cover is fitted together with the
upper chassis cover
69