Permobil M400 Corpus HD Service Manual page 24

M400 Corpus HD
6. Remove the four screws that hold the seat angle mechanism in
place. The seat angle mechanism can be mounted in six different
positions, depending on the depth of the seat. Note the position the
seat angle mechanism is mounted in for future reference. Lift the
seat angle mechanism off the seat lift/seat column.
4.1.3.2 Mounting the seat angle mechanism
1. Mount the Seat stabilizer brackets in the correct position, they
should be mounted in different positions depending on the seat
depth setting. See Table 2. Use a torque wrench to tighten the
screws. Tightening torque 18 lb·ft.
2. Mount the seat angle mechanism in the correct position using the
four screws. It should be mounted in different positions, depending
on the seat depth setting. The mounting position is defined by the
position of the seat post. See Table 2. Use a torque wrench to
tighten the screws. Tightening torque 18 lb·ft.
Table 2 The mounting position is defined by the position of the seat post
Seat Depth Seat stabilizer
Position bars
1: 18.5 in 2 + 5
2: 19.5 in 2 + 5
3: 20.5 in 2 + 5
4: 21.5 in 1 + 4
5: 22.5 in 2 + 5
6: 23.5 in 2 + 5
7: 24.5 in 2 + 5
24
Position Tilt to Tilt mechanism
center hole in Mounting holes
seatpost no:
A 1 + 1
B
2 + 2
C 3 + 3
D 4 + 1
E 4 + 1
F 4 + 2
F 4 + 2
Figure 23. The seat angle mechanism mounted in
position (B).
Figure 24. The mounting position for the Seat Angle
Mechanism (A) and the Seat stabilizer Bracket (B)
depends on the seat depth setting.
Figure 25. The seat angle mechanism mounted in
position (B). The four screws are mounted in position (2)
according to table below.
Repairs - Seat