Footplates - Permobil M400 Corpus HD Service Manual

M400 Corpus HD
4.1.16

Footplates

The following tools are necessary for this task:
• Allen key 5 mm
4.1.16.1 Removing footplate
WARNING!
Risk of injury while adjusting footplates
Do not place any weight or load on the footplates while adjusting the
footplates.
1. Switch off the main power switch on the control panel.
2. Remove the screw holding the footplate in place.
3. Remove the footplate friction brake by taking the parts off the shaft.
4. Remove the footplate by taking it off the shaft.
4.1.16.2 Mounting footplate
WARNING!
Risk of injury while adjusting footplates
Do not place any weight or load on the footplates while adjusting the
footplates.
1. Mount the footplate by sliding it onto the shaft.
2. Mount the footplate friction brake by sliding the parts onto the
shaft. Make sure that the metal butt is positioned in the intended
hole in the footplate.
3. Fit the screw that holds the footplate in place. Tighten the screw
using a torque wrench. Tightening torque 24 lb·ft.
42
Figure 63. The friction brake's metal butt is in place in
the intended hole in the footplate
Figure 64. The footplate and its friction brake
Repairs - Seat