Auxiliary Voltage Power Supply 24 Vdc (X10); Fusing; Wiring Example 24 Vdc Supply; Dc Bus Link (X3) - Kollmorgen AKD2G-S Series Installation Manual

8.6.2 Auxiliary voltage power supply 24 VDC (X10)

The following diagram describes external 24 VDC power supply (PELV). The required supply
current rating depends on the use of motor brake (➜ # 35) or (➜ # 37).
Pin Signal
1 + 24 V
2 GND

8.6.2.1 Fusing

Use 24 VDC supply manufacturers recommendation for fusing.
24 V supply (PELV)
Aux. voltage supply (PELV)
- control current without motor brake
- control current with one motor brake

8.6.2.2 Wiring example 24 VDC supply

Example for three phase power supply unit.

8.7 DC Bus link (X3)

Beta Drives: DC Bus sharing functionality is pending. Do not use this functionality until fur-
ther notice.
AKD2G-S Installation, Safety 1 | 8 Electrical Installation
2 pin, pitch 5.08 mm
Mating connector data see (➜ # 51).
Undervoltage fault limit 19 V
Overvoltage fault limit 30 V
Description
+24 VDC supply voltage, PELV
Ground for 24 VDC supply voltage, PELV
Units
VDC
A
A
Kollmorgen | kdn.kollmorgen.com | Beta, December 2018
Input data Input data
single axis dual axis
24 V (±10%, check voltage drop)
1 1.25
3.5 3.75
75