Information List - Siemens SIPROTEC 4 Manual

Functions
2.15 Automatic Reclosing System 79
Addr. Parameter
7260 bef.3.Cy:67-3
7261 bef.3.Cy:67N-3
7262 bef.4.Cy:67-3
7263 bef.4.Cy:67N-3

Information List

2.15.8
No. Information
127 79 ON/OFF
2701 >79 ON
2702 >79 OFF
2703 >BLOCK 79
2711 >79 Start
2715 >Start 79 Gnd
2716 >Start 79 Ph
2722 >ZSC ON
2723 >ZSC OFF
2730 >CB Ready
2731 >Sync.release
2753 79 DT delay ex.
2754 >79 DT St.Delay
2781 79 OFF
2782 79 ON
2784 79 is NOT ready
2785 79 DynBlock
2788 79 T-CBreadyExp
2801 79 in progress
2808 79 BLK: CB open
2809 79 T-Start Exp
2810 79 TdeadMax Exp
2823 79 no starter
2824 79 no cycle
2827 79 BLK by trip
2828 79 BLK:3ph p.u.
2829 79 Tact expired
2830 79 Max. No. Cyc
2844 79 1stCyc. run.
230
Setting Options
Set value T=T
instant. T=0
blocked T=∞
Set value T=T
instant. T=0
blocked T=∞
Set value T=T
instant. T=0
blocked T=∞
Set value T=T
instant. T=0
blocked T=∞
Type of Comments
Informa-
tion
IntSP 79 ON/OFF (via system port)
SP >79 ON
SP >79 OFF
SP >BLOCK 79
SP >79 External start of internal A/R
SP >Start 79 Ground program
SP >Start 79 Phase program
SP >Switch zone sequence coordination ON
SP >Switch zone sequence coordination OFF
SP >Circuit breaker READY for reclosing
SP >79: Sync. release from ext. sync.-check
OUT 79: Max. Dead Time Start Delay expired
SP >79: Dead Time Start Delay
OUT 79 Auto recloser is switched OFF
IntSP 79 Auto recloser is switched ON
OUT 79 Auto recloser is NOT ready
OUT 79 - Auto-reclose is dynamically BLOCKED
OUT 79: CB ready monitoring window expired
OUT 79 - in progress
OUT 79: CB open with no trip
OUT 79: Start-signal monitoring time expired
OUT 79: Maximum dead time expired
OUT 79: no starter configured
OUT 79: no cycle configured
OUT 79: blocking due to trip
OUT 79: blocking due to 3-phase pickup
OUT 79: action time expired before trip
OUT 79: max. no. of cycles exceeded
OUT 79 1st cycle running
Default Setting Comments
Set value T=T before 3. Cycle: 67-3
Set value T=T before 3. Cycle: IE>>> directional
Set value T=T before 4. Cycle: 67-3
Set value T=T before 4. Cycle: 67N-3
E50417-G1140-C343-A8, Edition 12.2017
SIPROTEC 4, 7SJ80, Manual