E2677B Differential Solder-In Head With Full Bw Resistors - Keysight Technologies 1130B User Manual

2. E2677B Differential Solder-in Head with Full BW Resistors

This probe configuration provides the
full bandwidth signals and the lowest
capacitive loading for measuring both
single-ended and differential signals.
This head allows a soldered connection into a system for a reliable, hands-free
connection. At the tip it uses a miniature axial lead resistor with 8 mil diameter
leads which allows connection to very small, fine pitch targets.
Table 11 Bandwidth
Probe Amplifier
1130B
1131B
Figure 24 E2677B
The probe head resistors must be soldered to the circuit that you are measuring.
Because of the small size of the resistor leads, it is easy to solder them to very
small geometry circuits.
To install or repair resistor leads. Refer to
N OT E
Solder-In Probe Heads"
Performance plots. Refer to
N OT E
Performance Data Plots,
"1134B Performance Data Plots.
1130B-Series Probes User's Guide
BW (GHz) Probe Amplifier
1.5 1132B
3.5 1134B
"Replacing Resistors on E2677B/9B
on page 74".
Chapter 5, "1130B Performance Data Plots,
Chapter 7, "1132B Performance Data Plots, and
2
Using Probe Heads
BW (GHz)
5
7
Chapter 6, "1131B
Chapter 8,
49