Table of Contents
Advertisement
Table 28 Characteristics and Specifications (Sheet 2 of 2)
Item
Input Resistance
Differential mode resistance
Single-ended mode resistance each side to
ground
Input Dynamic Range
Input Common Mode Range
Maximum Signal Slew Rate (SR
DC Attenuation
Zero offset error referred to input
Offset Range
Offset Accuracy
Noise referred to input
Propagation Delay
Maximum Input Voltage
ESD Tolerance
* Values shown are for the probe amp and solder-in differential probe head with full bandwidth resistor.
b >- Denotes that bandwidth is a warranted specification, all others are typical. Measured using the probe amplifier and solder- in differential probe head with full bandwidth resistor.
† SR
of a sine wave = 2 P(Amp x frequency or SR
max
page 18.
1130B-Series Probes User's Guide
Characteristic
50 kΩ ±2%
25 kΩ ±2%
±2.5 V
±6.75 V
±1.25 V
†
)
18 V/ns
max
30 V/ns
10:1 ±3% before calibration on oscilloscope
10:1 ±1% after calibration on oscilloscope
< 30 mV before calibration on oscilloscope
< 5 mV after calibration on oscilloscope
±12.0 V
< 3% of setting before calibration on oscilloscope
< 1% of setting after calibration on oscilloscope
3.0 mVrms
6 ns
30V Peak (mains isolated)
> 8 kV from 100 pF, 300 Ω HBM
) of a step @ Amp x 0.6 / trise (20 to 80%) for more information refer to
max
*
Characteristics and Specifications
Description
Differential or single-ended
dc to 100 Hz
> 100 Hz to probe bandwidth (should
not exceed the maximum signal slew
rate)
When probing a single-ended signal
When probing a differential signal
When probing single-ended
Maximum non-destructive voltage on
each input ground
Table 2
4
on
93
Advertisement
Table of Contents
