Table of Contents
Advertisement
• Ensure that there is less thermal stress on the probe head as well as DUT by:
• Do not apply heat on the probe tip leads for a time period longer than two
• Use a small solder iron tip (<1mm is recommended).
• No clean (non-conductive) and less acidic flux is recommended.
• While disconnecting the probe head from the MX0103A bullet adapter:
1130B-Series Probes User's Guide
•
Good working distance from the sample (at least 4 inches)
•
Adjustable arm
•
Integrated ring light around the objective lens
•
Using a high quality temperature controlled soldering iron with the tip
temperature set as low as possible (just high enough to melt the alloy).
•
Using a low temperature solder alloy such as SAC (Tin / Silver / Copper)
o
with 220
C melting point), or tin-bismuth solder with 138
seconds.
•
either gently pull the bullet adapter from the probe head by hand
•
or engage a flat screwdriver on the notch provided on the bullet adapter and
gently disconnect the probe head from bullet adapter.
2
Using Probe Heads
o
C melting point.
45
Advertisement
Table of Contents
