Ip Interface Commands; Basic Ip Configuration; Table 4-73 Ip Interface Commands - SMC Networks SMC TigerStack 1000 SMC8724M Management Manual

IP Interface Commands

An IP addresses may be used for management access to the switch over
your network. The IP address for this switch is obtained via DHCP by
default. You can manually configure a specific IP address, or direct the
device to obtain an address from a BOOTP or DHCP server when it is
powered on. You may also need to a establish a default gateway between
this device and management stations or other devices that exist on another
network segment.

Basic IP Configuration

Command
ip address
ip dhcp restart
ip default-gateway
show ip interface
show ip redirects
ping

Table 4-73 IP Interface Commands

Function
Sets the IP address for the current
interface
Submits a BOOTP or DCHP client
request
Defines the default gateway through
which this switch can reach other
subnetworks
Displays the IP settings for this device
Displays the default gateway configured
for this device
Sends ICMP echo request packets to
another node on the network
IP I C
NTERFACE
Mode Page
IC
PE
GC
PE
PE
NE,
PE
OMMANDS
4-288
4-289
4-289
4-291
4-291
4-292
4-287