therefore remember to save the current configuration after
renumbering the stack.
•
For a line topology, the stack is numbered from top to bottom, with
the first unit (i.e., the unit with no connection on the Up port) in the
stack designated as unit 1. For a ring topology, the Master unit taken as
the top of the stack and is numbered as unit 1 and all other units are
numbered sequentially down through the ring.
Web – Click System, Renumbering.
CLI – Use the reload command to restart the switch.
Console#switch all renumber
Console#
Resetting the System
Web – Click System, Reset. Click the Reset button to restart the switch.
When prompted, confirm that you want to reset the switch.
CLI – Use the reload command to restart the switch.
Console#reload
System will be restarted, continue <y/n>?
Note: When restarting the system, it will always run the Power-On
Self-Test.
Figure 3-19 Renumbering the Stack
Figure 3-20 Resetting the System
B
C
ASIC
ONFIGURATION
4-33
4-29
3-41