Queue Mode; Table 4-64 Priority Commands (Layer 2) - SMC Networks SMC TigerStack 1000 SMC8724M Management Manual

C L
OMMAND INE
Priority Commands (Layer 2)
Command

queue mode

switchport priority
default
queue bandwidth
queue cos map
show queue mode
show queue
bandwidth
show queue cos-map Shows the class-of-service map
show interfaces
switchport
queue mode
This command sets the queue mode to strict priority or Weighted
Round-Robin (WRR) for the class of service (CoS) priority queues. Use the
no form to restore the default value.
Syntax
queue mode {strict | wrr}
no queue mode
• strict - Services the egress queues in sequential order, transmitting
all traffic in the higher priority queues before servicing lower
priority queues.
• wrr - Weighted Round-Robin shares bandwidth at the egress ports
by using scheduling weights 1, 2, 4, 6, 8, 10, 12, 14 for queues 0 - 7
respectively.
4-260
I
NTERFACE

Table 4-64 Priority Commands (Layer 2)

Function
Sets the queue mode to strict priority or
Weighted Round-Robin (WRR)
Sets a port priority for incoming untagged
frames
Assigns round-robin weights to the
priority queues
Assigns class-of-service values to the
priority queues
Shows the current queue mode
Shows round-robin weights assigned to
the priority queues
Displays the administrative and
operational status of an interface
Mode Page
GC 4-260
IC 4-260
GC 4-262
IC 4-263
PE 4-265
PE 4-265
PE 4-266
PE 4-186