Editing Vlan Groups; Vlan Database; Table 4-57 Editing Vlan Groups - SMC Networks SMC TigerStack 1000 SMC8724M Management Manual

C L
OMMAND INE
Command Groups
Configuring Private
VLANs
Configuring Protocol
VLANs

Editing VLAN Groups

Command

vlan database

vlan
vlan database
This command enters VLAN database mode. All commands in this mode
will take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, change, and delete
VLANs. After finishing configuration changes, you can display the
VLAN settings by entering the show vlan command.
• Use the interface vlan command mode to define the port
membership mode and add or remove ports from a VLAN. The
results of these commands are written to the running-configuration
file, and you can display this file by entering the show
running-config command.
4-236
I
NTERFACE
Table 4-56 VLAN Commands (Continued)
Function
Configures private VLANs, including uplink and
downlink ports
Configures protocol-based VLANs based on
frame type and protocol

Table 4-57 Editing VLAN Groups

Function
Enters VLAN database mode to add,
change, and delete VLANs
Configures a VLAN, including VID,
name and state
Page
4-247
4-247
Mode Page
GC 4-236
VC 4-237