Table of Contents
Advertisement
C
L
OMMAND
INE
Mirror Port Commands
This section describes how to mirror traffic from a source port to a target
port.
Command
port monitor
show port monitor Shows the configuration for a mirror port
port monitor
This command configures a mirror session. Use the no form to clear a
mirror session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
• interface - ethernet unit/port (source port)
• rx - Mirror received packets.
• tx - Mirror transmitted packets.
• both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is
for both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
4-188
I
NTERFACE
Table 4-47 Mirror Port Commands
Function
Configures a mirror session
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-24/48)
Mode Page
IC
4-188
PE
4-189
Advertisement
Table of Contents
