Cisco ASA Series Cli Configuration Manual page 686

Customizing EIGRP
•
•
•
•
•
•
•
Defining a Network for an EIGRP Routing Process
The Network table lets you specify the networks used by the EIGRP routing process. For an interface to
participate in EIGRP routing, it must fall within the range of addresses defined by the network entries.
For directly connected and static networks to be advertised, they must also fall within the range of the
network entries.
The Network table displays the networks configured for the EIGRP routing process. Each row of the
table displays the network address and associated mask configured for the specified EIGRP routing
process.
To add or define a network, perform the following steps:
Detailed Steps
Command
Step 1
router eigrp as-num
Example:
hostname(config)# router eigrp 2
Step 2
network ip-addr [mask]
Example:
hostname(config)# router eigrp 2
hostname(config-router)# network 10.0.0.0
255.0.0.0
Cisco ASA Series CLI Configuration Guide
1-6
Redistributing Routes Into EIGRP, page 1-12
Filtering Networks in EIGRP, page 1-14
Customizing the EIGRP Hello Interval and Hold Time, page 1-15
Disabling Automatic Route Summarization, page 1-16
Configuring Default Information in EIGRP, page 1-16
Disabling EIGRP Split Horizon, page 1-17
Restarting the EIGRP Process, page 1-18
Purpose
Creates an EIGRP routing process and enters router configuration
mode for this EIGRP process.
The as-num argument is the autonomous system number of the
EIGRP routing process.
Configures the interfaces and networks that participate in EIGRP
routing. You can configure one or more network statements with
this command.
Directly connected and static networks that fall within the defined
network are advertised by the ASA. Additionally, only interfaces
with an IP address that fall within the defined network participate
in the EIGRP routing process.
If you have an interface that you do not want to have participate
in EIGRP routing, but that is attached to a network that you want
advertised, see the "Configuring Passive Interfaces" section on
page 1-8.
Chapter 1 Configuring EIGRP