Cisco ASA Series Cli Configuration Manual page 1182

GTP Inspection
Configuring a GTP Inspection Policy Map for Additional Inspection
Control
If you want to enforce additional parameters on GTP traffic, create and configure a GTP map. If you do
not specify a map with the inspect gtp command, the ASA uses the default GTP map, which is
preconfigured with the following default values:
•
•
•
•
•
•
•
To create and configure a GTP map, perform the following steps. You can then apply the GTP map when
you enable GTP inspection according to the
section on page
Step 1
Create a GTP inspection policy map, enter the following command:
hostname(config)# policy-map type inspect gtp policy_map_name
hostname(config-pmap)#
Where the policy_map_name is the name of the policy map. The CLI enters policy-map configuration
mode.
Step 2
(Optional) To add a description to the policy map, enter the following command:
hostname(config-pmap)# description string
Step 3
To match an Access Point name, enter the following command:
hostname(config-pmap)# match [not] apn regex [regex_name | class regex_class_name]
Step 4
To match a message ID, enter the following command:
hostname(config-pmap)# match [not] message id [message_id | range lower_range upper_range]
Where the message_id is an alphanumeric identifier between 1 and 255. The lower_range is lower range
of message IDs. The upper_range is the upper range of message IDs.
Step 5
To match a message length, enter the following command:
hostname(config-pmap)# match [not] message length min min_length max max_length
Where the min_length and max_length are both between 1 and 65536. The length specified by this
command is the sum of the GTP header and the rest of the message, which is the payload of the UDP
packet.
Step 6
To match the version, enter the following command:
hostname(config-pmap)# match [not] version [version_id | range lower_range upper_range]
Where the version_id is between 0and 255. The lower_range is lower range of versions. The
upper_range is the upper range of versions.
Cisco ASA Series CLI Configuration Guide
1-4
request-queue 200
timeout gsn 0:30:00
timeout pdp-context 0:30:00
timeout request 0:01:00
timeout signaling 0:30:00
timeout tunnel 0:01:00
tunnel-limit 500
1-7.
Chapter 1 Configuring Inspection for Management Application Protocols
"Configuring Application Layer Protocol Inspection"