Cisco ASA Series Cli Configuration Manual page 722

Customizing Multicast Routing
Command
igmp version {1 | 2}
Example:
hostname(config-if)# igmp version 2
Configuring PIM Features
Routers use PIM to maintain forwarding tables for forwarding multicast diagrams. When you enable
multicast routing on the ASA, PIM and IGMP are automatically enabled on all interfaces.
Note
PIM is not supported with PAT. The PIM protocol does not use ports, and PAT only works with protocols
that use ports.
This section describes how to configure optional PIM settings and includes the following topics:
•
•
•
•
•
•
Enabling and Disabling PIM on an Interface
You can enable or disable PIM on specific interfaces. To enable or disable PIM on an interface, perform
the following steps:
Detailed Steps
Command
Step 1
pim
Example:
hostname(config-if)# pim
Step 2
no pim
Example:
hostname(config-if)# no pim
Note
Only the no pim command appears in the interface configuration.
Cisco ASA Series CLI Configuration Guide
1-10
Purpose
Controls the version of IGMP that you want to run on the interface.
Enabling and Disabling PIM on an Interface, page 1-10
Configuring a Static Rendezvous Point Address, page 1-11
Configuring the Designated Router Priority, page 1-11
Configuring and Filtering PIM Register Messages, page 1-12
Configuring PIM Message Intervals, page 1-12
Filtering PIM Neighbors, page 1-12
Purpose
Enables or reenables PIM on a specific interface.
Disables PIM on a specific interface.
Chapter 1 Configuring Multicast Routing