Cisco ASA Series Cli Configuration Manual page 448

Starting ASA 5505 Interface Configuration
•
•
Default Speed and Duplex
By default, the speed and duplex are set to auto-negotiate.
Starting ASA 5505 Interface Configuration
This section includes the following topics:
•
•
•
•
Task Flow for Starting Interface Configuration
To configure interfaces in single mode, perform the following steps:
Step 1
Configure VLAN interfaces. See the
Step 2
Configure and enable switch ports as access ports. See the
Access Ports" section on page
Step 3
(Optional for Security Plus licenses) Configure and enable switch ports as trunk ports. See the
"Configuring and Enabling Switch Ports as Trunk Ports" section on page
Step 4
Complete the interface configuration according to
(Routed Mode),"
Configuring VLAN Interfaces
This section describes how to configure VLAN interfaces. For more information about ASA 5505
interfaces, see the
Guidelines
We suggest that you finalize your interface configuration before you enable Easy VPN.
Cisco ASA Series CLI Configuration Guide
1-6
Switch ports—Disabled.
VLANs—Enabled. However, for traffic to pass through the VLAN, the switch port must also be
enabled.
Task Flow for Starting Interface Configuration, page 1-6
Configuring VLAN Interfaces, page 1-6
Configuring and Enabling Switch Ports as Access Ports, page 1-7
Configuring and Enabling Switch Ports as Trunk Ports, page 1-9
or Chapter 1, "Completing Interface Configuration (Transparent Mode)."
"Information About ASA 5505 Interfaces" section on page
Chapter 1
"Configuring VLAN Interfaces" section on page
1-7.
Chapter 1, "Completing Interface Configuration
Starting Interface Configuration (ASA 5505)
"Configuring and Enabling Switch Ports as
1-9.
1-1.
1-6.