Cisco ASA Series Cli Configuration Manual page 359

Configuring Active/Standby Failover
This chapter describes how to configure Active/Standby failover and includes the following sections:
•
•
•
•
•
•
•
•
Information About Active/Standby Failover
This section describes Active/Standby failover and includes the following topics:
•
•
•
•
•
•
Active/Standby Failover Overview
Active/Standby failover enables you to use a standby ASA to take over the functionality of a failed unit.
When the active unit fails, it changes to the standby state while the standby unit changes to the active
state. The unit that becomes active assumes the IP addresses (or, for transparent firewall, the
management IP address) and MAC addresses of the failed unit and begins passing traffic. The unit that
is now in standby state takes over the standby IP addresses and MAC addresses. Because network
devices see no change in the MAC to IP address pairing, no ARP entries change or time out anywhere
on the network.
Information About Active/Standby Failover, page 1-1
Licensing Requirements for Active/Standby Failover, page 1-6
Prerequisites for Active/Standby Failover, page 1-6
Guidelines and Limitations, page 1-6
Configuring Active/Standby Failover, page 1-7
Controlling Failover, page 1-16
Monitoring Active/Standby Failover, page 1-18
Feature History for Active/Standby Failover, page 1-18
Active/Standby Failover Overview, page 1-1
Primary/Secondary Status and Active/Standby Status, page 1-2
Device Initialization and Configuration Synchronization, page 1-2
Command Replication, page 1-3
Failover Triggers, page 1-4
Failover Actions, page 1-5
1
C H A P T E R
Cisco ASA Series CLI Configuration Guide
1-1