Cisco ASA Series Cli Configuration Manual page 402

Monitoring Active/Active Failover
Step 5
When you are finished, you can restore the unit or failover group to active status by enter the following
command on the unit where the failover group containing the interface connecting your hosts is active:
Monitoring Active/Active Failover
To monitor Active/Active Failover, perform one of the following tasks. Commands are entered in the
system execution space unless otherwise noted.
Command
show failover
show failover group
show monitor-interface
show running-config failover
For more information about the output of the monitoring commands, see the Cisco ASA 5500 Series
Command Reference.
Feature History for Active/Active Failover
Table 1-3
Table 1-3 Feature History for Active/Active Failover
Feature Name
Active/Active failover
IPv6 Support in failover
Cisco ASA Series CLI Configuration Guide
1-26
hostname(config)# failover active group group_id
lists the release history for this feature.
Releases
7.0
8.2(2)
Chapter 1
Purpose
Displays information about the failover state of
the unit.
Displays information about the failover state of
the failover group. The information displayed is
similar to that of the show failover command but
limited to the specified group.
Displays information about the monitored
interface. Enter this command within a security
context.
Displays the failover commands in the running
configuration.
Feature Information
In an Active/Active failover configuration, both ASAs can
pass network traffic.
We introduced this feature and the relevant commands.
We modified the following commands: failover interface
ip, show failover, ipv6 address, show monitor-interface.
Configuring Active/Active Failover