Cisco ASA Series Cli Configuration Manual page 243

Chapter 1 Configuring Multiple Context Mode
Command
Step 4
config-url url
Example:
hostname(config-ctx)# config-url
ftp://user1:passw0rd@10.1.1.1/configlets/t
est.cfg
Step 5
(Optional)
member class_name
Example:
hostname(config-ctx)# member gold
Step 6
(Optional)
allocate-ips sensor_name [mapped_name]
[default]
Example:
hostname(config-ctx)# allocate-ips sensor1
highsec
Purpose
Identifies the URL from which the system downloads the context
configuration. When you add a context URL, the system
immediately loads the context so that it is running, if the
configuration is available.
Note
Enter the allocate-interface command(s) before you
enter the config-url command. If you enter the config-url
command first, the ASA loads the context configuration
immediately. If the context contains any commands that
refer to (not yet configured) interfaces, those commands
fail.
The filename does not require a file extension, although we
recommend using ".cfg". The server must be accessible from the
admin context. If the configuration file is not available, you see
the following message:
WARNING: Could not fetch the URL url
INFO: Creating context with default config
For non-HTTP(S) URL locations, after you specify the URL, you
can then change to the context, configure it at the CLI, and enter
the write memory command to write the file to the URL location.
(HTTP(S) is read only).
Note
The admin context file must be stored on the internal flash
memory.
Available URL types include: disknumber (for flash memory),
ftp, http, https, or tftp.
To change the URL, reenter the config-url command with a new
URL. See the "Changing the Security Context URL" section on
page 1-27 for more information about changing the URL.
Assigns the context to a resource class. If you do not specify a
class, the context belongs to the default class. You can only assign
a context to one resource class.
Assigns an IPS virtual sensor to this context if you have the IPS
module installed.
See the "Assigning Virtual Sensors to a Security Context (ASA
5510 and Higher)" section on page 1-16
about virtual sensors.
Cisco ASA Series CLI Configuration Guide
Configuring Multiple Contexts
for detailed information
1-23