Cisco ASA Series Cli Configuration Manual page 405

Starting Interface Configuration
(ASA 5510 and Higher)
This chapter includes tasks for starting your interface configuration for the ASA 5510 and higher,
including configuring Ethernet settings, redundant interfaces, and EtherChannels.
Note
This chapter only applies to the ASA 5500 series appliances; for the ASASM, starting interface
configuration consists of configuring switch ports and VLANs on the switch, and then assigning VLANs
to the ASASM according to
ASA Services Module."
Configuration (Routed Mode),"
(Transparent Mode)."
For ASA 5505 configuration, see
For multiple context mode, complete all tasks in this section in the system execution space. To change
from the context to the system execution space, enter the changeto system command.
For ASA cluster interfaces, which have special requirements, see
ASAs."
This chapter includes the following sections:
•
Information About Starting ASA 5510 and Higher Interface Configuration, page 1-2
•
Licensing Requirements for ASA 5510 and Higher Interfaces, page 1-8
•
Guidelines and Limitations, page 1-10
•
Default Settings, page 1-12
•
Starting Interface Configuration (ASA 5510 and Higher), page 1-13
•
Monitoring Interfaces, page 1-34
•
Configuration Examples for ASA 5510 and Higher Interfaces, page 1-34
•
Where to Go Next, page 1-35
•
Feature History for ASA 5510 and Higher Interfaces, page 1-36
Chapter 1, "Configuring the Switch for Use with the
To complete your interface configuration, see
or Chapter 1, "Completing Interface Configuration
Chapter 1, "Starting Interface Configuration (ASA 5505)."
1
C H A P T E R
Chapter 1, "Completing Interface
Chapter 1, "Configuring a Cluster of
Cisco ASA Series CLI Configuration Guide
1-1