Cisco ASA Series Cli Configuration Manual page 784

Configuring Network Object NAT
•
•
•
•
•
Adding Network Objects for Mapped Addresses
For dynamic NAT, you must use an object or group for the mapped addresses. Other NAT types have the
option of using inline addresses, or you can create an object or group according to this section. For more
information about configuring a network object or group, see the
Groups" section on page
Guidelines
•
•
•
•
•
•
Cisco ASA Series CLI Configuration Guide
1-4
Configuring Dynamic NAT, page 1-5
Configuring Dynamic PAT (Hide), page 1-7
Configuring Static NAT or Static NAT-with-Port-Translation, page 1-11
Configuring Identity NAT, page 1-14
Configuring Per-Session PAT Rules, page 1-16
1-2.
A network object group can contain objects and/or inline addresses of either IPv4 or IPv6 addresses.
The group cannot contain both IPv4 and IPv6 addresses; it must contain one type only.
See the "Guidelines and Limitations" section on page 1-2
IP addresses.
Dynamic NAT:
–
You cannot use an inline address; you must configure a network object or group.
–
The object or group cannot contain a subnet; the object must define a range; the group can
include hosts and ranges.
–
If a mapped network object contains both ranges and host IP addresses, then the ranges are used
for dynamic NAT, and then the host IP addresses are used as a PAT fallback.
Dynamic PAT (Hide):
–
Instead of using an object, you can optionally configure an inline host address or specify the
interface address.
–
If you use an object, the object or group cannot contain a subnet; the object must define a host,
or for a PAT pool, a range; the group (for a PAT pool) can include hosts and ranges.
Static NAT or Static NAT with port translation:
–
Instead of using an object, you can configure an inline address or specify the interface address
(for static NAT-with-port-translation).
–
If you use an object, the object or group can contain a host, range, or subnet.
Identity NAT
–
Instead of using an object, you can configure an inline address.
–
If you use an object, the object must match the real addresses you want to translate.
Chapter 1 Configuring Network Object NAT
"Configuring Network Objects and
for information about disallowed mapped