Cisco ASA Series Cli Configuration Manual page 683

Chapter 1 Configuring EIGRP
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single and multiple context mode.
Firewall Mode Guidelines
Supported only in routed firewall mode. Transparent firewall mode is not supported.
Failover Guidelines
Supports Stateful Failover in single and multiple context mode.
IPv6 Guidelines
Does not support IPv6.
Clustering Guidelines
•
•
Additional Guidelines
•
•
Configuring EIGRP
This section describes how to enable the EIGRP process on your system. After you have enabled EIGRP,
see the following sections to learn how to customize the EIGRP process on your system.
•
•
Supports Layer 2 and Layer 3 clustering when configured to use both EIGRP and OSPFv2.
In a Layer 3 cluster setup, EIGRP adjacencies can only be established between two contexts on a
shared interface on the master unit. You can manually configure multiple neighbor statements
corresponding to each cluster node separately to work around this issue.
EIGRP instances cannot form adjacencies with each other across shared interfaces because
inter-context exchange of multicast traffic is not supported.
A maximum of one EIGRP process is supported.
Enabling EIGRP, page 1-4
Enabling EIGRP Stub Routing, page 1-4
Guidelines and Limitations
Cisco ASA Series CLI Configuration Guide
1-3