Cisco ASA Series Cli Configuration Manual page 1105

Chapter 1 Getting Started with Application Layer Protocol Inspection
Table 1-2
Keywords
ipv6 [map_name]
mgcp [map_name]
netbios [map_name]
pptp
radius-accounting [map_name]
rsh
rtsp [map_name]
scansafe [map_name]
sip [map_name]
skinny [map_name]
snmp [map_name]
sqlnet
Protocol Keywords
Configuring Application Layer Protocol Inspection
Notes
If you added an IP Options inspection policy map according
to "(Optional) Configuring an IPv6 Inspection Policy Map"
section on page 11-68, identify the map name in this
command.
If you added an MGCP inspection policy map according to
"Configuring an MGCP Inspection Policy Map for
Additional Inspection Control" section on page
identify the map name in this command.
If you added a NetBIOS inspection policy map according to
"Configuring a NetBIOS Inspection Policy Map for
Additional Inspection Control" section on page
identify the map name in this command.
—
The radius-accounting keyword is only available for a
management class map. See the
Map for Management Traffic" section on page 1-15
information about creating a management class map.
If you added a RADIUS accounting inspection policy map
according to "Configuring a RADIUS Inspection Policy
Map for Additional Inspection Control" section on page
identify the map name in this command.
—
If you added a RTSP inspection policy map according to
"Configuring an RTSP Inspection Policy Map for Additional
Inspection Control" section on page
name in this command.
If you added a ScanSafe (Cloud Web Security) inspection
policy map according to "Configuring a Service Policy to
Send Traffic to Cloud Web Security" section on page
identify the map name in this command.
If you added a SIP inspection policy map according to
"Configuring a SIP Inspection Policy Map for Additional
Inspection Control" section on page
name in this command.
If you added a Skinny inspection policy map according to
"Configuring a Skinny (SCCP) Inspection Policy Map for
Additional Inspection Control" section on page
identify the map name in this command.
If you added an SNMP inspection policy map according to
"Configuring an SNMP Inspection Policy Map for
Additional Inspection Control" section on page
identify the map name in this command.
—
Cisco ASA Series CLI Configuration Guide
1-13,
1-30,
"Creating a Layer 3/4 Class
for more
1-9,
1-16, identify the map
25-11,
1-20, identify the map
1-26,
1-10,
1-11