Cisco ASA Series Cli Configuration Manual page 1106

Configuring Application Layer Protocol Inspection
Table 1-2
Keywords
sunrpc
tftp
waas
xdmcp
Step 6
To activate the policy map on one or more interfaces, enter the following command:
hostname(config)# service-policy policymap_name {global | interface interface_name}
Where global applies the policy map to all interfaces, and interface applies the policy to one interface.
By default, the default policy map, "global_policy," is applied globally. Only one global policy is
allowed. You can override the global policy on an interface by applying a service policy to that interface.
You can only apply one policy map to each interface.
Cisco ASA Series CLI Configuration Guide
1-12
Chapter 1
Protocol Keywords
Getting Started with Application Layer Protocol Inspection
Notes
The default class map includes UDP port 111; if you want to
enable Sun RPC inspection for TCP port 111, you need to
create a new class map that matches TCP port 111, add the
class to the policy, and then apply the inspect sunrpc
command to that class.
—
—
—