Cisco ASA Series Cli Configuration Manual page 1107

Configuring Inspection of Basic Internet
Protocols
This chapter describes how to configure application layer protocol inspection. Inspection engines are
required for services that embed IP addressing information in the user data packet or that open secondary
channels on dynamically assigned ports. These protocols require the ASA to do a deep packet inspection
instead of passing the packet through the fast path. As a result, inspection engines can affect overall
throughput.
Several common inspection engines are enabled on the ASA by default, but you might need to enable
others depending on your network.
This chapter includes the following sections:
•
•
•
•
•
•
•
•
•
•
•
•
•
DNS Inspection
This section describes DNS application inspection. This section includes the following topics:
•
•
•
DNS Inspection, page 1-1
FTP Inspection, page 1-10
HTTP Inspection, page 1-15
ICMP Inspection, page 1-20
ICMP Error Inspection, page 1-20
Instant Messaging Inspection, page 1-20
IP Options Inspection, page 1-24
IPsec Pass Through Inspection, page 1-25
IPv6 Inspection, page 1-26
NetBIOS Inspection, page 1-30
PPTP Inspection, page 1-32
SMTP and Extended SMTP Inspection, page 1-32
TFTP Inspection, page 1-35
Information About DNS Inspection, page 1-2
Default Settings for DNS Inspection, page 1-2
(Optional) Configuring a DNS Inspection Policy Map and Class Map, page 1-3
1
C H A P T E R
Cisco ASA Series CLI Configuration Guide
1-1