Cisco ASA Series Cli Configuration Manual page 589

Software version 9.0 for the services module
Hide thumbs Also See for ASA Series:
Table of Contents

Advertisement

Chapter 1
Adding a Webtype Access Control List
Adding Remarks to Access Lists
You can include remarks about entries in any access list, including extended, EtherType, IPv6, standard,
and Webtype access lists. The remarks make the access list easier to understand.
To add a remark after the last access-list command you entered, enter the following command:
Command
access-list access_list_name remark text
Example:
hostname(config)# access-list OUT remark -
this is the inside admin address
Example
You can add a remark before each ACE, and the remarks appear in the access list in these locations.
Entering a dash (-) at the beginning of a remark helps set it apart from an ACE.
hostname(config)# access-list OUT remark - this is the inside admin address
hostname(config)# access-list OUT extended permit ip host 209.168.200.3 any
hostname(config)# access-list OUT remark - this is the hr admin address
hostname(config)# access-list OUT extended permit ip host 209.168.200.4 any
What to Do Next
Apply the access list to an interface. See the
information.
Monitoring Webtype Access Lists
To monitor webtype access lists, enter the following command:
Command
show running-config access list
Configuration Examples for Webtype Access Lists
The following example shows how to deny access to a specific company URL:
hostname(config)# access-list acl_company webtype deny url http://*.example.com
Purpose
Adds a remark after the last access-list command you entered.
The text can be up to 100 characters in length. You can enter leading spaces
at the beginning of the text. Trailing spaces are ignored.
If you enter the remark before any access-list command, then the remark
is the first line in the access list.
If you delete an access list using the no access-list access_list_name
command, then all the remarks are also removed.
"Configuring Access Rules" section on page 1-7
Purpose
Displays the access-list configuration running on
the ASA.
Cisco ASA Series CLI Configuration Guide
What to Do Next
for more
1-5

Advertisement

Table of Contents
loading

Table of Contents